Cino Fuzzyscan MBC6890 series Uživatelská příručka stáhnout pdf (Strana 22)

Establish SPP Slave Connection

While configuring the MBC6890 to be used in SPP Slave mode, the

imager will only wait for the connection request issued by the remote

Bluetooth master system to establish the radio link. Once the pre-built

radio link is lost, user has to re-build the radio link manually.

Generally speaking, Widcomm provides complete Windows

based

Bluetooth software and its stacks have been broadly adopted by the

Bluetooth industry. The following procedures of installation example

described how to connect MBC6890 to a remote host system in

Windows 2000 with Widcomm Bluetooth driver for your reference.

The Installation Procedures

(1) Make sure that batteries are fully charged and placed into

MBC6890. You may refer to Section “Preparations Before Using”

for details.

(2) Power on the remote Bluetooth host system and make sure the

virtual COM port is available for connecting to MBC6890. If the

virtual COM port is not available, please go to the folder of

“Client Applications” located in Bluetooth advanced setting,

then add an additional COM port by clicking the “Add COM

Port” button.

(3) Power on the MBC6890 imager within radio range. Then check

that MBC6890 gives alternating red-green blinks, means it is in

“Uninstall” state. If the imager has been in “Uninstall” state

already, the next step can be skipped.

(4) Scan the “Uninstall” barcode command. The imager gives 4

short beeps. Then imager LED gives alternating red-green

blinks.

Uninstall

Quick Set Command

The imager will automatically switch to “Sleep State” in 30

seconds, if there’s no further operation under “Uninstall State”.

Press the imager trigger switch to wake up the imager from

“Sleep State”.

MBC6890 User’s Guide

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Žádné komentáře

Cino Fuzzyscan MBC6890 series Uživatelská příručka Strana 22